Everything published on Standing Seam STL, newest first. This site covers St. Louis and the greater St. Louis area, and every page on it is written to be useful on its own rather than to lead somewhere. Keys Roofing is the contractor behind it and the phone number on every page reaches the Keys office directly.
A homeowner reading any one of these is usually part way through a decision and short of one specific fact. The list below says what each page answers, so you can go to the one you need instead of reading the site.
- Concealed Fasteners and Exposed Fasteners Standing seam hides its fasteners under a raised seam. Corrugated exposed fastener panel drives screws through the face and relies on a rubber washer. How to tell them apart before you buy.
- Do You Need 24 Gauge Metal, or Is 26 Gauge Enough? The gauge affects stiffness, handling and price, but it does not tell you whether the whole standing seam assembly is properly specified.
- Hail, Dents and Your Policy Wording Metal is very unlikely to leak from hail and very likely to dent. Cosmetic damage exclusions, what to ask your carrier before you buy, and what the NOAA hail record for St. Louis does and does not say.
- Questions to Ask Before You Commit to Metal Six questions that separate a standing seam specialist from a contractor who will quote one, plus the questions that belong to your carrier, your building division and your tax preparer instead.
- Snow, Ice, Noise and Movement Snow shedding and where it lands, snow retention clamped to the seam, why metal does not repeal ice dams, the rain noise myth, and the thermal movement that makes a metal roof tick.
- The Deck Underneath a Metal Roof Plank decking, cupped boards and oil canning: why the deck matters more under standing seam than under anything else, plus underlayment, ventilation and the St. Louis County permit triggers.
- The Paint Finish on Your Metal Roof Is Part of the Spec Here is how PVDF and SMP finishes differ, where fading shows first, and what your St. Louis metal roof quote should name.
- What Drives the Price of a Standing Seam Roof No made up price per square. The line items that actually move a standing seam number: gauge, seam type, run length, penetrations, trim fabrication, deck preparation and snow retention.
- What a Standing Seam Roof Actually Is Panels that run ridge to eave, clips hidden under a raised seam, snap lock versus mechanically seamed, and the three specifications that make two metal quotes comparable.
- Where a Metal Roof Earns Its Cost Low slope sections, long unbroken panel runs, porches and additions: the specific St. Louis situations where standing seam is genuinely the right call, and the longevity claim read carefully.
- Where Standing Seam Is the Wrong Roof Cut up roofs, wavy plank decks, resale in an asphalt market and the money that would be better spent on decking, flashing and ventilation. The honest argument against a metal roof.
Nothing on this site is advice about an insurance claim. Under RSMo 407.725 a roofing contractor in Missouri may not represent or negotiate a homeowner's claim, and may not offer anything about a deductible. What Keys does is document the damage, put a written scope with photographs and measurements in your hands, and attend as the contractor. You deal with your own insurer.